Great job on your thesis presentations!
After all the hard work and preparation, you all did an amazing job presenting your research.
Congratulations and well done!

doctoral thesis

• LIU Yuxing
  Development of a predictive model for optimal calcium addition derived from the unraveling of calcium modification mechanisms of Al₂O₃ inclusions in molten steel
• Shi Chonglin
   Precipitation Behavior of MnAl₂O₄ Spinel in Manganese-Bearing Slag Systems」

master's thesis

• ONO Shintaro
  「Measurement of the activity coefficient of CuFe₂O₄ in Fe₃O₄-CuFe₂O₄ solid solutions」
  
• TERASHIMA Daichi
  「Measurement of Activity Coefficient of SrO in Molten Slag」
  
• FUKUI Yuto
  Evaluation of the Effect of Mn concentration on Copper Sulfide Precipitation in Low Carbon Steel
  
• IMABAYASHI Koki / Yasui Lab.
  ・Koki Imabayashi：Stabilization of novel aqueous quasi-solid electrolytes
• Hikaru Kajihara / Yasui Lab.
  Growth and Characterization of Titanite-type Ca(Ti,Mn)SiO₅ Thin Films
• Satoshi Kurahashi/ Yasui Lab.
  Fabrication and Dielectric Characterization of Titanite-Type CaMxTi1-xSiO₅ (M = Zr, Sn) Thin Films
• NOMURA Ryota / Yasui Lab
  Ryota Nomura：Interfacial Reaction Control of Active Materials in Aqueous Quasi-Solid-State Batteries via a Sacrificial Layer
• MOHAMAD AMIRUN/ Yasui Lab
  Mohamad Amirun：Study on Stable Solidification of Radionuclides using Whitlockite for ALPS Sediment Waste Treatment

undergraduate thesis

• KATAOKA Shuji
  Effect of Third Element Addition on Oxygen Dissolution Behavior in Molten Aluminum Alloys
  
• FUKUSHIMA Naoki
  Measurement of the Reduction Rate of Molten Iron Oxide by CO Gas Injection
  
• KAWAGOE Aito
  Evaluation of CO₂ Absorption Capacity of Molten Slag
• SOEDA Hikaru/ Yasui Lab.
  水系準固体電池技術のスケールアップを目指した3D-SLISEの液相合成